Caronlab Advanced Fusion Beads 800gm

Description

Caronlab Advanced+ Stripless Fusion Wax – Total Body Waxing Made Simple

Discover the ultimate in professional waxing with Caronlab’s Advanced+ Stripless Fusion Wax – Specially formulated for total body waxing, this high-performance wax blends the best qualities of hard wax, strip wax, and film wax into one luxurious, easy-to-use product.

Whether you’re performing facial waxing, leg waxing, or intimate waxing treatments, Advanced+ delivers consistently flawless results with unmatched comfort and control.

Why Choose Advanced+ Stripless Fusion Wax?

• Suitable for all skin types and hair textures
• Ideal for full body waxing – face, arms, legs, bikini, and more
• Flexible, low-temperature formula for maximum comfort
• No strips needed – mess-free and easy to apply
• Perfect for professional salons and confident beginner therapists
• Made by Caronlab Australia – trusted by professionals worldwide

Usage Instructions – Stripless Fusion Wax

1. Area to be Waxed must be clean, dry and free from any oils and creams. Caronlab Australia recommends the use of Prep – Pre Wax Skin Cleanser as it has been designed to work together for best results with Caronlab Australia Waxes. Always test Wax on the inside of your wrist before use. Do not apply on warts, moles and broken or irritated skin.
2. You may begin by dipping Spatula into Wax, which should be the consistency of thick honey.
3. Apply Wax with the hair growth, leaving one edge thicker to create a lip. Fusion Wax should be applied in a thin layer.
4. Hold skin taut and remove Wax by pulling in the opposite direction of hair growth.
5. For the perfect finish we recommend you use Caronlab Soothe After Waxing Soothing Lotion Mango & Witch Hazel or Tea Tree to complete your treatment. As Advanced+ does not leave a sticky Wax residue, after waxing oil is not required.
6. To clean equipment use Solvent – Wax Remover Citrus Clean.

Heating Instructions – Beads

1. Place Beads into the Professional Wax Heater Advanced+ 3lt or Caronlab Australia Wax Heater Insert, no higher than ¾ full.
2. Heat on the highest setting for 20 minutes DO NOT Stir during this time.
3. When Wax is completely melted, turn down to 75 degrees (167°F) on your Advanced+ Professional Wax Heater 3lt or between dial 3-4 on a Caronlab Australia Professional Wax
4. Dip Spatula into the Wax, which should be the consistency of thick honey, if its dripping it is too hot.
5. DO NOT block the edges of the Insert or Wax Heater when topping up Beads. NO MORE than a scoop at a time.
6. Always work from a ¾ full Wax Heater.

Important

Store in a cool, dry place.

Caution and Warning

Low temperature Wax. This is a professional product for Salon use only. Patch test before use. Do not Wax over moles, warts, broken or irritated skin. If irritation occurs, cease use. Exceeding the recommended heating instructions may cause burns and / or injury.